T O P

Printer keeps not filling the wall and it keeps making this super weak part I don’t know what to do. Also I’m getting bad stringing so it could be to much retraction or too little I don’t know.

Printer keeps not filling the wall and it keeps making this super weak part I don’t know what to do. Also I’m getting bad stringing so it could be to much retraction or too little I don’t know.

AutoModerator

Hello /u/jumppybrat, As a reminder, most common print quality issues can be found in the [Simplify3D picture guide](https://www.simplify3d.com/support/print-quality-troubleshooting/). Make sure you select the most appropriate flair for your post. Please remember to include the following details to help troubleshoot your problem. * Printer & Slicer * Filament Material and Brand * Nozzle and Bed Temperature * Print Speed * Nozzle Retraction Settings ^Additional ^settings ^or ^relevant ^information ^is ^always ^encouraged. *I am a bot, and this action was performed automatically. Please [contact the moderators of this subreddit](/message/compose/?to=/r/FixMyPrint) if you have any questions or concerns.*


littlebroiswatchingU

Thicken your walls and it’s either you have a clog or your walls are too thin


ratolloko

Check your flow calibration. If not coggled nozzle, the flow doesn't look right


jumppybrat

How do I do that?


ratolloko

https://teachingtechyt.github.io/calibration.html#flow


jumppybrat

Thank you stranger