T O P

First layer adhesion issue.

First layer adhesion issue.

AutoModerator

Hello /u/jumppybrat, As a reminder, most common print quality issues can be found in the [Simplify3D picture guide](https://www.simplify3d.com/support/print-quality-troubleshooting/). Make sure you select the most appropriate flair for your post. Please remember to include the following details to help troubleshoot your problem. * Printer & Slicer * Filament Material and Brand * Nozzle and Bed Temperature * Print Speed * Nozzle Retraction Settings ^Additional ^settings ^or ^relevant ^information ^is ^always ^encouraged. *I am a bot, and this action was performed automatically. Please [contact the moderators of this subreddit](/message/compose/?to=/r/FixMyPrint) if you have any questions or concerns.*


jumppybrat

(Op) when I tried to use higher temps I went to 80c bed and 220 nozzle and it kinda worked better but still messed up. I am using PLA from sunlu it may be bad filament but I really hope that’s not the case.


IgneousAssBarf

You may just need to get your nozzle a bit closer to the glass so you get more squish


jumppybrat

Did that. It acts like it is too far away but it’s still the correct level


IgneousAssBarf

> It acts like it is too far away but it’s still the correct level Then it's too far away and you need to be closer lol. Level and "close enough" are not the same thing. Your bed can be perfectly "level" down to a fraction of an Angstrom but if it's not close enough to the nozzle the filament still won't print.


[deleted]

It happens to me all the time if I dont use washable Glue Stick.