T O P

I can’t get my print to stick to the bed. It keeps sliding mid print and messing up. The first one went well and went for 20 hours but eventually shifted. And the second went for maybe 15 hours and it looks like it just slid off the bed. I have tried higher temps and it seems to fail sooner.

I can’t get my print to stick to the bed. It keeps sliding mid print and messing up. The first one went well and went for 20 hours but eventually shifted. And the second went for maybe 15 hours and it looks like it just slid off the bed. I have tried higher temps and it seems to fail sooner.

LiveItDifferent

Is z-hop enabled? Try to clean the bed and spray it with a thin layer of hair spray


Shawndie76

Turn off economy mode if it's an Ender.


Matzurai

We need more details. What temperatures are you using? Do you change them after the first layer? What material are you trying to print? Also your print bed looks like a mess - seems like your nozzle hit it multiple times, so bad bed leveling might be an issue. You might consider changing it for a new pei foil if those are 'old scars' and you got your bed leveling under control.


_craker_

Tried printing with a brim or raft? (Cura). You could try different filament.


urinal_deuce

Check your belts.